   |
Now in: Installing Your TNP121 |
Installing your new TNP121 Tilt 'N Plug Jr. Tabletop Interconnect Box
Follow these simple steps and use the Cutout Guide to install your Altinex TNP121
Step 1 - Cut an opening into the table's surface.
Note: The table can be 2.25" or less in thickness. Always confirm dimensions before cutting to insure that specifications have not changed.
Step 2 - Insert the Tilt 'N Plug Jr. into the table cutout.
Step 3 - Place the support brackets under the table in between the support mount grooves on the side of the Tilt 'N Plug Jr. (See Diagram 5 for details.) Attach the brackets to the groove at the desired height and secure them to the bottom of the table using the thumb screws provided.
Step 4 - Secure the cables by using the provided cable clamps and screws included with the unit. Pass the power cord from the bottom of the housing and attach it to the table using the cable clamp and screw supplied with the Tilt 'N Plug Jr. Leave enough slack in the service loop to allow for easy opening and closing, but not too much as to cause excess drooping of the service loop.
Step 5 - Connect the appropriate cables with the correct input connectors on the bottom of the unit.
Step 6 - Once you have applied power and connected the proper cables on the bottom of the unit you may raise the unit. To raise the Tilt 'N Plug Jr. into position, push down on the front of the top cover; the latching mechanism will then release, allowing the pneumatic spring to raise it into position.
Step 7 - To lower the unit, push on the top of the Tilt 'N Plug Jr. until it locks into place.